Frame Instructions: Bighorn I

Bighorn I Components: (2) Side Rails (2) Cross Bar (1) Seat Bar (1) Foot Bar (1) Pair of Oar Mounts (10) U-bolts (20) Washers and Locking Nuts (2) 9ft Straps (4) Strap Slides (1) Frame Wrench Low-Back Drain Hole Seat with bolts and washers Note: Seat is packaged separately

Directions

1. Lay out the frame parts as shown in the image above.


2. Set the seat, foot, and cross bars in place and add the U-bolts, nuts and washers leaving them loose. Be sure that the side marked "Front" on the seat plate faces forward. Adjust the cross bars so that they fit against the cooler or dry box snugly. If any of the bars need to be repositioned, it may be necessary to remove the U-bolts to make adjustments.
   
   Note: See Strap Slide Instructions.


3. Add seat, oar mounts, and straps.


4. Check to be sure that all of the U-bolts are tight. Periodically check the tightness of all nuts and bolts.

*Printable Bighorn I Frame Directions

* Adobe Acrobat 3.0 is required to view printable directions

Download Acrobat Reader