Frame Instructions

Cat Fish Frame Components: (2) Yokes (4) Side Rails (1) Foot Bar (1) Seat Bar (1) Action Seat Bar (1) Pair of Oar Mounts (16) U-bolts (32) Washers & Locking Nuts (1) Frame Wrench (1) High-Back Drain Hole Seat with bolts and washers (1) Action Swivel Seat with nuts, bolts and washers Note: Side Rails, and Seats are packaged separately

Directions

1. Lay out the frame parts as shown in the image above. Place the yokes upside down with the narrow end up.


2. Install the U-bolts on the inner yoke LoPro fittings. Add the washers and the nuts, leaving them loose. Slide the two inner side rails in through the U-bolts, then tighten the nuts.


3. Turn the yoke right side up so that the inner rails are supporting the frame. Follow step 2 with the outer rails.


4. Set the seat, foot and cross bars in place and add the U-bolts. Be sure that the side marked "Front" on the seat plates faces forward. Adjust the crossbars so that they fit against the cooler or dry box snugly. If any of the bars need to be repositioned it may be necessary to remove the U-bolts to make adjustments.
   
   Note: Bolt pattern on action seat plate designed for action swivel seat only.


5. Add seats and oar mounts.


6. Check to be sure that all of the U-bolts are tight. Periodically check the tightness of all nuts and seat bolts.

*Printable Cat Fish Frame Directions

* Adobe Acrobat 3.0 is required to view printable directions

Download Acrobat Reader